VPI Industries JMW-9T Bedienungsanleitung PDF herunterladen (Seite 2)

BEFORE YOU BEGIN

NOT FOLLOWING THIS MANUAL WILL VOID YOUR WARRANTEE.

FAILURE TO SEND IN THE WARRANTEE CARD WILL VOID YOUR WARRANTEE

• Be very careful when handling the tone arm. The internal arm wire is exposed at the

headshell and at the rear of the arm. This wire is very delicate and contains 64 strands of

pure copper. Physical damage to the wire is not covered by the warranty after the arm is

removed from its box.

• Please do not touch the unipivot bearing parts. Finger oils in the upper bearing housing or

on the lower pivot point in the arm base assembly can cause blemishing of the bearing

and possible corrosion. Also, the point is sharp, be careful.

SETTING UP THE JMW-9 WHEN THE CARTRIDGE IS NOT

FACTORY MOUNTED.

DO NOT TOUCH THE SETTINGS ON THE ARM IF THE CARTRIDGE WAS

FACTORY INSTALLED

• YOU WILL SEE A NUMBER OF THINGS IN PLASTIC BAGS:

• Allen wrench

• Hex nuts, and washers (for cartridge mounting)

• Arm mounting and alignment tool

• Remove the arm tube from the box (taking special care not to strain or damage, the

delicate 4-color wire and Lemo connector) and place it right side up on a foam pad.

• The aluminum has a glass beaded finish, do not rub anything hard against this finish

as it will be damaged and your warrantee does not cover scratches or damage to the

finish.

• FOR CARTRIDGES WITH THREADED MOUNTING HOLES:

• Use the screws supplied by the cartridge manufacturer to mount the cartridge. Any

other screws may not fit the thread properly and may even damage the thread and

cartridge. USE ONE OF THE SUPPLIED WASHERS UNDER THE SCREW HEAD.

• FOR CARTRIDGES WITH PASS THROUGH HOLES:

• For all cartridges with pass through mounting holes use the hardware supplied with the

arm. Remember to USE THE WASHERS UNDER THE SCREW HEAD to prevent

damage to the finish on the JMW-9 arm.

• In this step, the connectors will be attached to the cartridge's terminals.

1 2 3 4 5 6

Keine Kommentare

VPI Industries JMW-9T Bedienungsanleitung Seite 2